Installing a Brick Paver Walkway or Concrete Masonry Bricks

The usage of Bricks or Pavers to produce a walkway or patio area complements a house in a method that is unmatched. In addition, setting up a Brick or Paver pathway does not always require a pro.

The key to setting up a Brick or Paver Walkway is to first effectively prepare the location where the bricks/pavers are to be installed. The location needs to be removed at least a foot down, getting rid of all topsoil and clay soil. In addition, string lines ought to be strung on each side of the sidewalk. The string lines suggest the finished height of the sidewalk.
As soon as the location has been dug down, 3/4" gravel stone must be laid in and tamped down securely. The height between the tamped down sand and the stringline must equate to the thickness of the brick or paver.

Now that you have a stable base, place a 1" pipeline or ledger board the length of the walkway on either side of the pathway. Using a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will develop a level area to lay the bricks/pavers.

Now place on the level sand/stone dust strips of plastic brick borders. Set up a run on both sides of the prepared area. These strips will act as your walkway border and help to maintain the integrity and shape of the sidewalk.

The secret to laying the bricks/pavers is to make sure that they interlock with each other. Constantly stagger nearby rows of bricks by 1/2 of a brick to interlock them. This will again help maintain the integrity of the pathway.

Inevitably bricks/pavers will need to be cut or divided when constructing the pathway. Unless you wish to purchase or rent an expensive wetsaw, I would recommend acquiring an easy brick/paver splitter. It is essentially a chisel with a large end that is the width of the bricks/pavers. To really cut/split the brick/paver, lay it in a bed of sand and place the sculpt at a 75 degree angle over the spot where you want to break the brick. Then utilizing a hammer strike the butt end of the sculpt firmly. You might need to do this website a number of times. You might also wish to flip the brick/paver over and strike the opposite of the brick utilizing the hammer and chisle. Within one or two strikes the brick/paver need to break cleanly. , if your pathway has curves you will require to buy/rent a wetsaw.

.

After installing the bricks, construct up the outside edges with extra sand, and then shovel in the topsoil and load down strongly.
Spread stone dust over the new sidewalk and sweep into the cracks. This will complete the interlocking of the bricks and help to remove any weed growth.


In addition, installing a Brick or Paver pathway does not always need a pro. The key to setting up website a Brick or Paver Walkway is to very first properly prepare the area where the bricks/pavers are to be installed. Now that you have a steady base, position a 1" pipeline or ledger board the length of the walkway on either side of the pathway. These strips will act as your sidewalk border and aid to maintain the integrity and shape of the pathway. Inevitably bricks/pavers will require to be cut or divided when constructing the sidewalk.

Leave a Reply

Your email address will not be published. Required fields are marked *